Checking The Error Description With The Cc Ie Control Diagnostics - Mitsubishi Electric MELSEC Q Series Reference Manual

10.4
Checking the Error Description with the CC IE Control
Diagnostics
This section describes the method of checking the error description with the CC IE Control diagnostics.
Check network information display.
Page 528, Section 10.3.1
Has communication error occurred?
Is there any disconnected station?
Is there any faulty station?
Start
Occurred
Not occurred
Yes
(Black)
No
Yes
No
End
CHAPTER 10 TROUBLESHOOTING
Select the station to which the faulty cable is
connected, and check the error details.
Cable disconnection or line being established
Page 543, Section 10.4.1
Cable insertion error
Page 545, Section 10.4.2
Connect Programming tool to the disconnected station,
and start the CC IE Control diagnostics.
Select the faulty station and check the error details.
Monitoring timeout
Page 547, Section 10.4.3
Parameter unreceived
Page 548, Section 10.4.4
Own station No. is out of range
Page 549, Section 10.4.5
Own station is set as reserved station
Page 551, Section 10.4.6
Own station No. duplication
Page 553, Section 10.4.7
Control station duplication
Page 556, Section 10.4.8
Control station duplication and own station No.
duplication
Page 559, Section 10.4.9
Illegal network No.
Page 561, Section 10.4.10
CPU module stop error
Page 563, Section 10.4.11
CPU module power stop error
Page 565, Section 10.4.12
External power not supplied
Page 566, Section 10.4.13
10
541