Mitsubishi Electric MELSEC Q Series Reference Manual page 168

(b) Setting network parameters in the programming tool
1.
Set the control station to the circuit test mode.
After setting the following network parameters in the programming tool, write them to the programmable
controller.
When a network contains a redundant system, pairing settings are required for network parameters of the control station.
Select "Pairing" of "Network Range Assignment" of the control station to configure the settings. (
6.3.4)
2.
Setting the normal station to the online mode
After setting the following network parameters in the programming tool, write them to the programmable
controller.
166
Page 199, Section