10.4.9
Control station duplication and own station No. duplication
The following explains the procedures to be taken when control station or station No. is duplicated.
(1) Turning ON all stations simultaneously
Stations other than duplicated control stations do not receive parameters since they recognize that no control
station exists in a network. (
Control
station
Selected
Normal station
No.1
station
No.2
Control station
Normal station
No.1
No.3
If it is difficult to identify the error cause, perform the CC IE Control diagnostics after the circuit test. (
Section 5.6.1)
Page 548, Section 10.4.4)
Select the own station.
There are multiple control stations with the same station No.
Change the network type and station No.
The current control station is not displayed, indicating that no control station exists.
CHAPTER 10 TROUBLESHOOTING
Page 165,
559
10