Mitsubishi Electric MELSEC Q Series Reference Manual page 180

Item
Pairing
Network
Specify Reserved
Range
Station
Assignment
Supplementary
Setting
Network Operation Settings
Refresh Parameters
Interrupt Settings
Redundant Settings
Interlink Transmission
Parameters
Routing Parameters
*1 A default value has been set. Change it if necessary.
*2 CPU modules that can be used differ depending on the connection path. (
178
Description
If the network contains a redundant system, set a
combination of stations of system A and system B.
Set reserved station(s).
Set the constant link scan time, block data assurance per
station, punctuality assurance, and the maximum number
of transient transmissions for one station.
The IP address of the CC-Link IE Controller Network
module is set to communicate data with Ethernet devices
over CC-Link IE Controller Network.
Set the range of the transfer between the link devices of
the CC-Link IE Controller Network module and the CPU
module devices.
Set the conditions for sending an interrupt request to the
CPU module.
For a Redundant CPU, set the operation mode of the CC-
Link IE Controller Network module on system B.
Set the link device transfer range between network
modules.
Set a relay station in the own network to transmit data to
another network.
CPU module
1) 2) 3) 4) 5) 6)
*1
×
× ×
×
: Setting required, : Set it if required, ×: Setting not allowed
Page 107, Section 4.3.1)
Reference
section
Page 199,
Section 6.3.4
Page 200,
Section 6.3.5
Page 201,
*1 *1 *1
Section 6.3.6
Page 203,
*2
× ×
Section 6.4
Page 204,
Section 6.5
Page 225,
Section 6.6
Page 231,
× ×
Section 6.7
Page 232,
Section 6.8
Page 238,
Section 6.9