Refresh Parameters; Refresh Parameter Setting - Mitsubishi Electric MELSEC Q Series Reference Manual

6.5

Refresh Parameters

6.5.1

Refresh parameter setting

Set the range of the transfer between the link devices of the CC-Link IE Controller Network module and CPU module
devices.
● The number of refresh parameter settings per module is shown below.
Item
Link device transfer
SB/SW transfer
*1 For the safety CPU with a serial number (first five digits) of "14051" or earlier, the number of refresh parameter settings
per module (except for SB/SW transfer) is 8.
● LB/LW data can be transferred exceeding the B/W capacity of the CPU module (8K points). (
6.5.2)
● The link device data of a CC-Link IE Controller Network module can be directly read/written by a sequence program.
( Page 70, Section 4.1.4)
1.
Configure the network setting. (
2.
Open the setting window in the programming tool.
Project window
3.
Configure settings with reference to the description below.
4.
Click the
204
High Performance model QCPU,
Process CPU, Redundant CPU,
Basic model
Q00UJCPU, Q00UCPU, Q01UCPU,
QCPU
8
Page 180, Section 6.2)
[Parameter] [Network Parameter]
button
button.
Number of settings
*1
and safety CPU
64
1 for each
[Ethernet/CC IE/MELSECNET]
Universal model QCPU
(other than Q00UJCPU,
Q00UCPU, and Q01UCPU)
256
Page 212, Section