Mitsubishi Electric MELSEC Q Series Reference Manual page 177

(d) Routing parameters of the relay station 1
(e) Routing parameters of the relay station 2
(3) Executing the communication test
1.
Open the "Communication Test" window in the programming tool.
[Diagnostics]
2.
Configure settings with reference to the description below.
3.
Click the
Item
Network No.
Target Station
Station No.
Data Length
Communication
Communication Count
Data Setting
Communication Timeout
[CC IE Control Diagnostics]
button.
Set the network No. of the communication target.
(Setting range: 1 to 239, Default: 1)
Set the station No. of the communication target.
(Setting range for Universal model QCPU: 0 to 120, Default: 1)
(Setting range for other than Universal model QCPU: 0 to 64, Default: 1)
Set the length of the communication data.
(Unit: Bytes) (Setting range: 1 to 900, Default: 100)
Set the number of communications.
(Setting range: 1 to 100, Default: 1)
Set a timeout time of the communication test. (Unit: Seconds)
(Setting range: 1 to 100, Default: 5)
CHAPTER 5 PREPARATION AND SETUP
button
Description
5
175