If it is difficult to identify the error cause, perform the CC IE Control diagnostics after the circuit test. (
Section 5.6.1)
(2) Adding station to a network
(a) When a programming tool connected station is normally operating
Control
station
Selected
Normal station
No.1
station
No.2
Added station
Control station
Normal station
No.4
No.3
Control station
Normal station
No.1
No.2
Added station
Control
Normal station
Selected
station
No.3
station
No.4
Select the own station.
An error has occurred in the station No.4.
Select the station No.4.
Click the error details button.
The Error Factor field indicates that a station other than the station No.4 has
been also set as the control station.
Take corrective actions according to the troubleshooting.
CHAPTER 10 TROUBLESHOOTING
Page 165,
557
10