Mitsubishi Electric MELSEC Q Series Reference Manual page 390

Device Item
(S1)+12
Clock data on
to
error completion
(S1)+15
Error-detected
(S1)+16
*2
network No.
Error-detected
(S1)+17
*2
station No.
*1 The setting side is as shown below.
User: Before execution of the link dedicated instruction, data must be set by the user.
System: The CPU module stores the execution result of the link dedicated instruction.
*2 Data is not stored when Completion status ((S1)+1) is "Channel busy (Dedicated instruction) (error code: E26C
The number of resends ((S1)+7) must be set every time an instruction is executed.
388
Setting data
Clock data on error completion are stored in BCD format. Data is
stored only when 1 is set in the bit 7 of Error completion type
((S1)+0). Note that the stored value will not be cleared even after the
dedicated instruction is completed.
b15 to
Month (01 to 12
(S1)+12
H
Hour (00 to 23
(S1)+13
H
Second (00 to 59
(S1)+14
H
(S1)+15 Year (00 to 99 ) First 2 digits
H H
When the target station is QnACPU, "00
(first two digits of the year).
Network No. of the station, where an error was detected, is stored.
Data is stored only when 1 is set in the bit 7 of Error completion type
((S1)+0). Note that the stored value will not be cleared even after the
dedicated instruction is completed.
1 to 239: Network No.
Station No. of the station, where an error was detected, is stored.
Data is stored only when 1 is set in the bit 7 of Error completion type
((S1)+0). Note that the stored value will not be cleared even after the
dedicated instruction is completed.
1 to 120: Station No.
b8 b7 to b0
)
Year (00 to 99 ) Last 2 digits
H
H H
) Day (01 to 31 )
H H H
) Minute (00 to 59 )
H H H
Day of week (00 to 06
H H
00 (Sun.) to 06 (Sat.)
H H
" is stored in the Year field
H
Setting range
—
)
—
—
Setting
*1
side
System
System
System
)".
H