Tests For Cc-Link Ie Controller Network Startup - Mitsubishi Electric MELSEC Q Series Reference Manual

5.6

Tests for CC-Link IE Controller Network Startup

This section describes the tests to be executed at startup of the CC-Link IE Controller Network.
The tests check whether the network operates properly or not at system startup.
Perform each test according to the following.
Configuring network system
Connect CC-Link IE Controller Network modules
with optical fiber cables.
Turn ON the external power supply. Check the
power supply module's POWER LED and the
CC-Link IE Controller Network module's RUN LED
are ON.
Checks the network cable connection status, line
status, and each station's parameter setting status
from the control station.
Page 165, Section 5.6.1
Network is operating normally.
164
Start
Power-on
Circuit test
When failed
Test result?
When completed normally
End
By the CC IE Control diagnostics, check the error
detail and take corrective actions.
When checking the cable
between faulty stations
Station-to-station test
Checks the status of the cable connected between
2 stations (from OUT of executing station to IN of
target station).
Page 169, Section 5.6.2