J(P)/G(P).Riwt (Data Write To Programmable Controllers On Target Station) - Mitsubishi Electric MELSEC Q Series Reference Manual

9.20
J(P)/G(P).RIWT (Data Write to Programmable Controllers
on Target Station)
This instruction writes the specified points of data to the target station's device.
Internal device
Setting
(System, User)
data
Bit Word
(S1) —
(S2) —
(D)
[Instruction [Execution
symbol] condition]
J.RIWT
JP.RIWT
G.RIWT
GP.RIWT
(1) Setting data
Setting data
Jn
Un
(S1)
(S2)
(D)
*1 Local devices and file registers for each program cannot be used as devices used in setting data.
Link direct
File
device J\
register
R, ZR
Bit
[Instruction format]
Start contact
Start contact
Start contact
Start contact
*1
Network number of the own station (1 to 239, 254)
254: The network specified in Valid module during other station access
Start I/O number of the own station's CC-Link IE Controller Network module
(00 to FE : The higher two digits of the 3-digit I/O number)
H
Start device of the own station that stores control data.
( Page 490, Section 9.20 (2))
The own station's start device where write data are stored.
The own station's device that is turned on for one scan upon completion of the
instruction.
(D) + 1 also turns on if the instruction execution has failed.
CHAPTER 9 DEDICATED INSTRUCTIONS
Available devices
Intelligent
function
module device
Word
U\G
—
—
—
Jn
J.RIWT
Jn
JP.RIWT
Un
G.RIWT
Un
GP.RIWT
Description
Constant
Index
Others
register Zn
K,H $
(S1) (S2) (D)
(S1) (S2) (D)
(S1) (S2) (D)
(S1) (S2) (D)
Data type
Binary 16 bits
Device name
Bit
9
489