Confirm The Results Of The Cutting Test; Adjustment Of Offset; Adjustment For Cutting Out; Adjustment When Using Plotting Pen - GRAPHTEC CE6000-120AP User Manual

Confirm the Results of the Cutting Test
Confirm the cutting test results, and adjust to optimal setting. Repeat cutting test and adjustment until optimal cut
is achieved.

Adjustment of Offset

Check the corners of the triangles and rectangles. See "Setting the Tool Condition"
offset value if the corner is not cut or if it is cut too much.
Supplement
How to check offset:
Check if the offset value is set correctly by following.

Adjustment for Cutting Out

Adjust so the media is completely cut out.
If the media is not completely cut, either the FORCE setting is too low or the cutter blade tip is not sufficiently
extended.
See "Adjusting the Blade Length"

Adjustment When Using Plotting Pen

Adjust the FORCE so there will be no faint lines. To prolong the pen life, set the FORCE to the lowest setting
without any faint lines. See"Setting the Force"
UP length
P.2-2 and "Setting the Force"
P.2-35 or setting the FORCE.
2-42
P.2-30
Not enough adjustment.
Increase the offset value.
Optimal offset value.
Too much adjustment.
Decrease the offset value.
Check the UP length when cutting.
When the UP length is not enough, those that
are cut during cutting, may come off.
P.2-35 and adjust the settings.
and adjust the