GRAPHTEC CE6000-120AP User Manual page 4

Do not use the power cord if it is damaged.
•
Use of a damaged cord may result in electric shock or a fire
hazard due to current leakage.
•
Replace the power cord with a new one.
Unplug the power
cord from the socket
Do not use or store the plotter in a location exposed
to direct sunlight or the direct draft of an air
conditioner or heater.
•
Such locations may impair the
performance of the plotter.
Prohibited
Do not place any receptacle containing water or
other fluid on top of the plotter.
•
Fluid falling inside the plotter may cause electric shock or a
fire hazard due to current leakage.
Avoid water
Beware of
electrical shock
When disconnecting the power cord or interface
cable, do not pull on the cord/cable.
•
Such action will damage the cord/cable, resulting in a fire
hazard or electric shock.
Prohibited
Safety Precautions
WARNING
Be careful when handling the cutter blade.
•
Touching the blade with your bare hand may cause injury.
•
Do not touch the cutter blade while cutting is in progress.
CAUTION
Do not use the plotter in an excessively dusty or
humid location.
•
Such locations may impair the performance of the plotter.
Do not use the plotter in a location subject to
excessive mechanical vibration or electrical noise.
•
Such locations may impair the performance of the plotter.
If water or foreign matter enters the plotter,
discontinue use. Turn off the power and unplug the
power cord from the electrical socket.
•
Use of a damaged cord may result in electric shock or a fire
hazard due to current leakage.
•
Contact your sales representative or nearest Graphtec vendor
for repairs.
cord from the socket
iii
No touching
Prohibited
Prohibited
Unplug the power