Chapter 7: Settings Regarding Cutting Time - GRAPHTEC CE6000-120AP User Manual

Chapter 7:
Settings Regarding Cutting Time
Time necessary for cutting depends on the speed to move the tool and media, and efficiency of the operation.
It is best to cut slowly and carefully to cut precisely, but the speed is required to enhance the operational
efficiency. The setting needs to be in good balance considering the characteristics of the media and tools,
and the contents of the cutting data.
This chapter describes the settings affecting the cutting time.
In addition to this chapter, there are setting affecting the cutting times in following places.
P.2-30 Setting the Tool Condition
PRODUCT SUMMARY
7.1 Sorting the Cutting Data
7.2 Perform Automatic Pre Feed When Cut Data is
Received
7.3 Perform Automatic Pre Feed When Media is Set
(Initial Feed)
7.4 Setting Feed Speed for Pre Feed
7.5 Setting the Tool Up Speed
7.6 Setting the Tool Up Move
7-1