Test Program - Yamaha DME4io-ES Service Manual

TEST PROGRAM

∗ Tests the DME4io-ES/DME8i-ES/DME8o-ES.
DME4io-ES, DME8i-ES and DME8o-ES are collectively referred to as "DME Satellite" if descriptions are applicable to all
the models.
Caution
• Before executing the test program, save the data to an external device (such as a computer) with the backup function of
the DME Designer.
• For more information on the operation, refer to the DME Designer owner's manual.
• The test program is in the "Boot" program area and there are following restrictions depending on Boot version.
• In case of V2.xx, only the Satellite-C can be tested.
• In case of V3.xx, both the Satellite-C/ES can be tested.
Accordingly, check the versions of Boot and Program before executing test program and upgrade to V3.0 if the version
is lower than V3.0. Depending on Boot version, the panel LED lights as follows when the DME Satellite is started.
V2.0: The LED lights up for 500 msec. at fi rst.
V3.0: The LED lights up for 2,000 msec. at fi rst.
Table 1 Table for combinations of Boot and Program versions
<Satellite-ES>
V2.0
Boot
V3.0
* × : Operates without error or sound .
△ : Operates without error, but test program does not run.
1. Preparation
1-1. Required items
• DME Satellite unit (DME4io-ES, DME8i-ES, DME8o-ES)
• GPI Loop Back Test jig
• REMOTE Loop Back Test jig
• Switching Hub (100 Base-TX)
• NAI48-ES as a jig
• USB Cable
• LAN Cable (Straight cable, STP type)
• Dsub25P (YAMAHA compatible arrangement) cable for digital audio
• BNC Cable
• Unit for supplying Word Clock (01V96, etc.)
• Personal Computer; DOS/V machine (P-200 MHz or faster, Windows 2000/XP, Ethernet port)
• MY16AE: 1 pc. (or MY8AE: 2 pcs.)
* If the MY8AE is used, it is necessary to change cable connections during A/D test and D/A test.
Program
V2.0 V3.0
× △
× ○
DME4io-ES/DME8i-ES/DME8o-ES
: 1 pc.
: 1 pc.
: 1 pc.
: 1 pc.
: 1 pc.
: 4 pcs.
: 1 pc. – 2 pcs.
: 1 pc.
: 1 pc.
: 1 set
: 1 pc. – 2 pcs.
49