Giving The Patch A Name; Giving The Patch A Name (Name Edit Mode) - Yamaha MagicStomp Owner's Manual

Giving the patch a name

I Giving the patch a name (Name Edit Mode)
You can use up to 12 characters when making a name for a User Patch.
* Names of Preset Patches (P01-P99) can not be changed.
q
Press the [STORE] button.
"PRESS[STORE]1sec" appears in the lower half of the display.
U01¤DIST10000000
ó‡DRIVfiMSTRáTONE
w
Press and hold the ON/OFF switch until "NAME EDIT MODE" appears on the
display.
The cursor appears below the first character of the patch name.
U01:DIST10000000
PRESS[STORE]1sec
e
Move the cursor to change characters.
Use the – and + switches to move the cursor to the character you want to change, then use the
three knobs to select the character.
The characters that can
be set with each knob →
• Moves the cursor to the left
(←)
• Press simultaneously with
the [STORE] button to
delete the character
selected with the cursor.
* Holding down the switch (and
button) repeats the same opera-
tion continuously.
18
Press and hold
_
U01¤TIST10000000
Cursor
NAME EDIT MODE
A Z
to
(space)
U01:DIST10000000
PRESS[STORE]1sec
U01¤DIST10000000
NAME EDIT MODE
0 9 : ! " #
a z
to to
$ % & ' ( ) *
(space)
+ ,- . /
Current patch number
_
Cursor
(space)
• Moves the cursor to the
right (→)
• Press simultaneously
with the [STORE] button
to insert a space where
the cursor is.
* Holding down the switch (and
button) repeats the same op-
eration continuously.