Siemens SINAMICS S Series List Manual page 1035

r9781[0...1] SI checksum to check changes (Control Unit) / SI checksum chg CU
CU_CX32, CU_S Can be changed: -
Data type: Unsigned32
P-Group: Safety Integrated
Not for motor type: -
Min
-
Description: Additional check sum that is formed to check changes (fingerprint for the safety logbook functionality) to safety
parameters (that are relevant for checksums).
Index: [0] = Safety change tracking checksum functional
[1] = Safety change tracking checksum hardware dependent
Dependency: Refer to: p9601, p9729, p9799
Refer to: F01690
r9782[0...1] SI time stamp to check changes (Control Unit) / SI TimeStamp CU
CU_CX32, CU_S Can be changed: -
Data type: Floating Point
P-Group: Safety Integrated
Not for motor type: -
Min
- [h]
Description: Time stamp for the checksum that is saved in parameters p9781[0] and p9781[1] to track changes (fingerprint for
the safety logbook functionality) made to safety parameters.
Index: [0] = SI time stamp change tracking checksum functional
[1] = SI time stamp change tracking checksum hardware-dependent
Dependency: Refer to: p9601, p9729, p9799
Refer to: F01690
r9794[0...19] SI crosswise comparison list (Control Unit) / SI DCC_list CU
SERVO, VECTOR Can be changed: -
Data type: Unsigned16
P-Group: Safety Integrated
Not for motor type: -
Min
-
Description: Displays the number of the data that are being presently compared crosswise on the Control Unit.
Example:
r9794[0] = 1 (monitoring clock cycle)
r9794[1] = 2 (enable safety-related functions)
r9794[2] = 3 (SGE changeover, tolerance time)
r9794[3] = 4 (transition time, STOP F to STOP A)
...
The list of crosswise compared data is obtained dependent on the particular application.
Dependency: Refer to: r9894
Note: The complete list of numbers for data cross-check is listed in Fault F01611.
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Calculated: -
Dynamic index: -
Units group: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Max
- [h]
Calculated: -
Dynamic index: -
Units group: -
Max
-
Parameters
List of parameters
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
- [h]
Access level: 3
Func. diagram: 2802
Unit selection: -
Expert list: 1
Factory setting
-
1-1035