Siemens SINAMICS S Series List Manual page 1430

Faults and Alarms
Overview of faults and alarms
Note:
You can change the default properties of a fault or alarm by setting parameters.
References: /IH1/
The list of faults and alarms (see Chapter 3.2) provide information referred to the
properties of a message/report that have been set as standard. If the properties
of a specific message/report are changed, then the appropriate information may
have to be modified in this list.
Fault location (optional): Name
The fault location (optional), the name of the fault or alarm and the report number
all serve to identify the report (e.g. with the commissioning software).
Drive object:
For each message (fault/alarm) it is specified in which drive object this message
is present.
A message can belong to either one, several, or all drive objects.
Reaction: Default fault reaction (adjustable fault reaction)
Specifies the default reaction in the event of a fault.
The optional brackets indicate whether the default fault reactions can be changed
and which fault reactions can be adjusted via parameters (p2100, p2101).
Note:
See Chapter 3.1.1
Acknowledgment: Default acknowledgement (adjustable acknowledgement)
Specifies the default method of fault acknowledgement after the cause has been
eliminated.
The optional brackets indicate whether the default acknowledgement can be
changed and which acknowledgement can be adjusted via parameter (p2126,
p2127).
Note:
See Chapter 3.1.1
Cause:
Description of the possible causes of the fault/alarm A fault or alarm value is also
specified as an option.
3-1430
SINAMICS S120 Commissioning Manual
Chapter "Diagnostics"
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007