Avaya J100 Series Installing And Administering page 88

Phone configuration
The two modes are as follows:
- Alternate: Supports registration to one of the active controllers.
- Simultaneous: Supports registration to both the active controllers.
• Failback policy: Specifies the fall back policy.
The two modes are as follows:
- Auto: Active controller automatically recovers after failback.
- Admin: Active controller uses failback policy defined by the administrator.
Note:
Failback policy is not supported in an Open SIP setup.
• SIP proxy policy: Specifies whether the settings of SIP proxy servers are taken from
the 46xxsettings.txt file or can be edited by the user.
The two modes are as follows:
- Auto: The settings are taken from the 46xxsettings.txt file. The user can only
view the settings.
- Manual: The user can edit, delete, or create new server properties.
• User ID Field: Specifies whether during logging in the User ID field will be displayed on
the phone screen or not.
7. Select SIP proxy server to change SIP proxy server settings.
Caution:
Do not configure proxy settings manually while a user is logged in to the phone.
The phone displays the IP address of the server that you selected.
8. Press Select and use the Up and Down Arrow keys to view, add, or change the following
settings:
• SIP proxy: Specifies the IP address or DNS. The corresponding parameter is
SIP_CONTROLLER_LIST.
• Protocol: Specifies the type of protocol. The options are TCP or UDP. The
corresponding parameter is SIPSIGNAL.
• SIP Port: Specifies the SIP port. If no value is entered, SIP port uses 5060 as the
default port for UDP/TCP.
9. Press Save.
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
environment 88