Avaya J100 Series Installing And Administering page 450

Customizable parameters
Parameter name
SIP_CONTROLLER_LIST_2
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Default value
Null
environment
Description
This parameter replaces
SIP_CONTROLLER_LIST
for dual mode phones. It is
used to select the
registration address.
SIP_CONTROLLER_LIST
_2 is used on IPv6-only
phones to provide the list
of SIPv6 servers. SIPv4
servers are ignored in
IPv6-only mode.
Valid values are 0 to 255
characters in the dotted
decimal or colon-hex
format, separated by
commas without any
intervening spaces.
The SIP Proxy list has the
following format:
host[:port]
[;transport=xxx]
where
• host is IP addresses in
dotted-decimal format or
hex format.
• [:port] is the port
number. The default
value is 5,061 for TLS.
• [;transport=xxx] is
an optional transport
type where xxx is either
TLS or TCP The default
value is TLS.
A dual mode controller has
addresses of both families
within curly ({ }) brackets.
This parameter should not
be set and left at default.
Open SIP redundancy do
not support IPv6.
Table continues...
450