Avaya J100 Series Installing And Administering page 475

Parameter name
VLANSEP
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Default value
1
environment
List of configuration parameters
Description
Specifies whether VLAN
separation is enabled by
the built-in Ethernet switch
while the phone is tagging
frames with a non-zero
VLAN ID.
When VLAN separation is
enabled, only frames with
a VLAN ID that is the
same to the VLAN ID used
by the phone (as well as
priority-tagged and
untagged frames) is
forwarded to the phone.
Also, if the value of
PHY2VLAN is non-zero,
only frames with a VLAN
ID that is the same to the
value of PHY2VLAN (as
well as priority-tagged and
untagged frames) is
forwarded to the
secondary (PHY2)
Ethernet interface. Tagged
frames received on the
secondary Ethernet
interface will have their
VLAN ID changed to the
value of PHY2VLAN and
their priority value
changed to the value of
PHY2PRIO.
Value operation:
0: Disabled.
1: Enabled if L2Q,
L2QVLAN and
PHY2VLAN are set
appropriately (default).
Note:
Avaya J129 IP
Phonedoes not
support this
parameter.
Table continues...
475