Avaya J100 Series Installing And Administering page 27

• If the wall plate is pre-installed, fit the wall mount bracket over the wall plate.
2. Connect one end of the Ethernet cable to the network port of the phone and the other end
to the wall jack.
3. To attach the phone to the wall mount bracket, insert the two upper tabs of the bracket into
the slots on the back panel of the phone.
The lower pair of tabs rest against the back panel. The phone does not move when you
press a key on the phone.
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
environment
Hardware installation
27