Avaya J100 Series Installing And Administering page 347

Parameter name
DOT1XSTAT
DSCPAUD
DSCPAUD_FL
DSCPSIG
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Default value
0
46
43
34
environment
List of configuration parameters
Description
Specifies the 802.1X
supplicant operating
mode.
Value operation:
0: Supplicant disabled
1: Supplicant enabled, but
responds only to received
unicast EAPOL messages
2: Supplicant enabled;
responds to received
unicast and multicast
EAPOL messages
Specifies the layer 3
Differentiated Services
(DiffServ) Code Point for
audio frames generated by
the phone.
Valid values are from 0 to
63.
This parameter can also
be set through the LLDP,
which overwrites any
value in the settings file.
Specifies the DSCP value
for flash precedence or
priority level voice call.
Valid values are from 0 to
63.
Specifies the layer 3
Differentiated Services
(DiffServ) Code Point for
signaling frames
generated by the phone.
Valid values are 0 through
63.
This parameter can also
be set through LLDP,
which overwrites any
value set in the settings
file.
Table continues...
347