Avaya J100 Series Installing And Administering page 301

Parameter name
AUTO_SELECT_ANY_IDLE_APPR
AWAY_TIMER
AWAY_TIMER_VALUE
B
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Default value
0
1
30
environment
List of configuration parameters
Description
Specifies that any idle call
appearance (primary or
bridged) can be
automatically selected.
This parameter works
along with the parameter
CONF_TRANS_ON_PRIM
ARY_APPR.
Value operation:
• 0: Disabled. Both
parameters
AUTO_SELECT_ANY_I
DLE_APPR and
AUTO_SELECT_ANY_I
DLE_APPR are set to 0.
• 1: Enabled. The
parameter
CONF_TRANS_ON_PRI
MARY_APPR is set to 0.
Note:
Avaya J129 IP Phone
does not support this
feature.
Specifies whether the
phone must report an
away state.
Value operation:
• 0: Disabled.
• 1: Enabled.
Specifies the number of
minutes of idle time after
which the phone assumes
that the user is away from
the phone.
Valid values are from 1 to
1500 minutes.
Table continues...
301