Avaya J100 Series Installing And Administering page 121

Name
Registration Interval
Un-registration Wait Timer
(seconds)
Registration Wait Timer
(seconds)
Signaling IP Preference
Media IP Preference
Codecs and DTMF
OPUS
G.722
G.726
April 2020
Description
Specifies the time interval in seconds between two registrations to the SIP
proxy.
The valid value is an integer from 30 to 86,400. The default value is 900
seconds.
Specifies the time in seconds during which the phone waits before
terminating all SIP dialog and SIP registrations.
The valid value is an integer from 4 to 3,600. The default value is 32
seconds.
Specifies the time in seconds during which the phone waits for a response
message from registration. If no response message is received within this
time, the phone tries to register again.
The valid value is an integer from 4 to 3,600. The default value is 32
seconds.
This parameter is used by SIP signaling only on a dual mode phone (phone
with both IPv4 and IPv6 addresses configured) to select the preferred SIP
controller IP addresses.
The default value is IPv4.
Specifies the preference of SDP media group lines and the SDP answer/
offer format when phone is in dual mode.
The default value is IPv4.
Specifies whether the OPUS codec capability of the phone is enabled or
disabled.
The options are:
• Disabled
• Enabled WIDEBAND_20K (default)
• Enabled NARROWBAND_16K
• Enabled NARROWBAND_12K
Specifies whether the G.722 codec is enabled.
The options are:
• Disable
• Enable (default)
Specifies whether the G.726 codec is enabled.
The options are:
• Disable
• Enable (default)
Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Configuring the phone using the web interface
environment
Table continues...
121