Ipv4 And Ipv6 - Avaya J100 Series Installing And Administering

Servers, VLAN, and IP configuration
Destination port
The number used in the
Source Port field of the
SNMP query packet
received by the phone
443, unless explicitly
specified otherwise
514
The port number
specified in the test
request message
System-specific
FEPORT + 1 (if
FEPORT is even) or
FEPORT -1 (if FEPORT
is odd) or the port
number specified in a
CNA RTP test request
plus or minus one, as
with FEPORT
RTCPMONPORT
System-specific

IPv4 and IPv6

Avaya J100 Series IP Phones support IPv4 and IPv6 dual mode, as well as only IPv6 mode. All
the IPv4 functionality is retained for IPv6. IPv6 protocol is enabled by default.
Avaya J100 Series IP Phones support the following combinations of IPv4 and IPv6 IP address
configuration:
• Dual mode: Both IPv4 and IPv6 addresses are configured by using static addressing.
• Dual mode: Both IPv4 and IPv6 addresses are configured by using DHCP.
• IPv4 only mode.
April 2020
Source port
161
Any unused port number TLS/SSL packets
Any unused port number Transmitted Syslog
50000
Any unused port number Transmitted signaling
PORTAUD + 1 (if
PORTAUD is even) or
PORTAUD – 1 (if
PORTAUD is odd) or the
port number reserved for
CNA RTP tests plus or
minus one, as for
PORTAUD, above
PORTAUD + 1 (if
PORTAUD is even) or
PORTAUD – 1 (if
PORTAUD is odd)
Any unused port number Transmitted signaling
Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Use
Transmitted SNMP
messages
transmitted by the HTTP
client of the phone.
messages
Transmitted SLA Mon
agent test results
messages
protocol packets
RTCP packets
transmitted to the far-
end of the audio
connection
RTCP packets
transmitted to an RTCP
monitor
protocol packets
environment
Protocol
UDP or TCP
UDP
TCP
UDP
™
UDP
TCP
UDP
UDP
UDP
74