Avaya J100 Series Installing And Administering page 377

Parameter name
IGNORE_CONTACT_HEADER_DISPLAY_NAME
INGRESS_DTMF_VOL_LEVEL
INTER_DIGIT_TIMEOUT
IPV6DADXMITS
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Default value
0
-12dBm
5
1
environment
List of configuration parameters
Description
Specifies if the phone is
allowed to use a display
name from the Contact
header when there is no
display name in the PAI or
From headers. In
OpenSIP environment it is
recommended to set this
parameter to 1.
Value Operation:
• 0: A display name in the
Contact header is
permitted to be used
(default).
• 1: A display name in the
Contact header is
always ignored.
Specifies the power level
of tone, expressed in
dBm0.
Values can range from
-20dBm to -7dBm.
Specifies the number of
seconds that the phone
waits after a digit is dialed
before sending a SIP
INVITE.
Valid values are 1 through
10.
Specifies whether
Duplicate Address
Detection is performed on
tentative addresses, as
specified in RFC 4862.
Value operation:
• 0: DAD is disabled
• 1 to 5: Maximum number
of transmitted Neighbor
Solicitation messages.
Table continues...
377