Avaya J100 Series Installing And Administering page 85

• 9z011x+: Network Access Code ("9 for an outside line"), followed by dial tone, followed by at
least one digit – typical instance of Automatic Route Selection (ARS) for US access to
international numbers of unknown, and variable, length.
Additional parameters that affect dialing are as follows:
• COUNTRY - Country of operation for specific dial tone generation.
• PSTN_VM_NUM (PSTN access number for Voice Mail system) - This parameter specifies
the telephone number to be dialed automatically when the deskphone user presses the
Messaging button under a non-AST controller. The deskphone places a PSTN call out from
the local office and back in to the location that houses the voice mail server. Additional codes
necessary to reach a specific user's voice-mail box may also be included. Example 1. SET
PSTN_VM_NUM 96135550123
• ENABLE_REMOVE_PSTN_ACCESS_PREFIX - When the deskphone is operating with a
non-AST controller and the value of the parameter is 0, the PSTN access prefix, defined by
the parameter PHNOL, is retained in the outgoing number. If the value is 1, then the PSTN
access prefix is stripped from the outgoing number.
• PHNLAC - A string representing the deskphone's local area code. When set, this parameter
indicates the endpoint's local area code, which along with the parameter
LOCAL_DIAL_AREA_CODE, allows users to dial local numbers with more flexibility.
Example: SET PHNLAC 617
• LOCAL_DIAL_AREA_CODE - A flag indicating whether the user must dial the area code for
calls within same area code regions. When the parameter is 0, the user does not need to dial
the area code; when this parameter is 1, the user needs to dial the area code. When this
parameter is enabled (1), the area code parameter (PHNLAC) should also be configured (i.e.,
not the empty string). Example: SET LOCAL_DIAL_AREA_CODE 1
Example 1 - Setting the parameter configuration:
• SET ENHDIALSTAT 2
• SET PHNOL 27
• SET PHNCC 1
• SET PHNDPLENGTH 7
• SET PHNLDLENGTH 11
• SET PHNLD 0
• SET PHNIC 001
Table 1: : Example 2 In the Contacts list, save Contact X with the telephone number 41018989
PHNLAC Parameter
Value
020
April 2020
LOCAL_DIAL_AREA_C
ODE Parameter Value
1
Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Configuring the phone using Administration menu
Step to Execute
Call X from Contacts list
environment
Result
Phone sends an invite
message with
2702041018989.
Table continues...
85