Remote Control - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.6.4.4
Part No.: 4417340 Revision 1
If the [Status Behavior]
not be activated if the scanned PV or SV health is Bad or Uncertain.
☛
Set the [Status Behavior] entity either to <BAD>, <BAD-
UNCERTAIN>, or <Not Used>.
NOTE:This behavior takes priority over the
monitoring. For example: If the
the scanned PV or SV health is Bad, the respective relay will be
activated regardless of the
or [Local] option PV or SV checks will then not affect the relay status.

Remote Control

In [Remote Control] mode, each individual relay can directly be
activated or deactivated, by sending an
!Deactivate! command via the CAN bus.
The behavior of each individual relay is further controlled by the
[Remote Control] mode entity, which can be set to either
or <Not Restricted>.
 If the [Remote Control] mode entity is set to
Restricted>,
with an !Activate!
 If the [Remote
the relay can only be controlled by the source that matches
the values set in the
Instance],
☛
From the [Remote Control]
<Not Restricted>.
☛
If Not Restricted was selected, skip to
☛
Select [Control Board ID],
☛
Select [Control Board Instance],
☛
Select [Control Function Instance],
Service Manual
954 SmartServo FlexLine
is set to <Not Used>,
[Status Behavior]
[Monitor Mode]
!Activate!
any source can be used to control the relay
or a !Deactivate!
Control] mode entity is set to
[Control Board ID],
and the [Control Function Instance].
mode menu, select either <Restricted> or
set proper value.
set proper value.
set proper value.
the respective relay will
[Remote] or [Local]
is set to <BAD>,
entity settings. The [Remote]
respectively a
<Restricted>
<Not
command.
<Restricted>,
the [Control Board
0.
and
103