Hcm-Gpu Board Specific; Baud Rate; Turn Around Delay - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
Figure 7-29
Part No.: 4417340 Revision 1
Reset device button: All modules of the SmartLink are reset
Reset board button: Only the HCM-GPU module is reset
Software version: Current installed software version for the HCM-GPU
module.
The TAB sheet Board Specific provides host communication
information as baud rate and turn around delay time (Refer to Figure

"HCM-GPU Board Specific").

HCM-GPU Board Specific

Baud rate

Host communication baud rate of the SmartLink. The default setting is
38400. When required, the baud rate can be changed. The following
settings are possible:
 115200
 57600
 38400
 19200
 9600
 4800
 2400
 1200
To make the change effective, press the Send button. When the baud
rate is changed, also change the baud rate at the COM port icon (two
levels higher).

Turn around delay

Service Manual
954 SmartServo FlexLine
167