Introduction; References - Honeywell FlexLine SmartServo 954 Service Manual

GENERAL
4417340
4417341
4417342
Part No.: 4417340 Revision 1
About this manual
This manual is a detailed how to reference for servicing the 954
SmartServo FlexLine.
For installing, wiring, configuring, starting up, operating, maintaining and
calibrating refer to the 954 SmartServo FlexLine Installation guide listed
below in References.
For Safety instructions and procedures refer to the 954 SmartServo
FlexLine Safety manual listed below in References.

Introduction

The 954 SmartServo FlexLine is an automatic tank gauge measuring
the surface or interface level of crude oil or derived products stored in a
bulk storage tank. Typically those storage tanks are available on
terminals, production plants and refineries in the petro-chemical, oil and
gas industry. The environment on those sites is typically explosion
hazardous.
The end user will typically use the 954 SmartServo FlexLine together
with a Terminal Inventory System for custody transfer operations, so
Weights and Measures legislation is applicable.
The 954 SmartServo FlexLine is based on the modular FlexConn board
architecture. Every FlexConn board supported in this device is
described in detail.
Revision History
954 Service Manual (This document)
1.0

References

The following list identifies publications that may contain information
relevant to the information in this document.
1
1
Service Manual
954 SmartServo FlexLine
March 2019 (1 st Release)
954 SmartServo FlexLine Installation Guide
954 SmartServo FlexLine Safety Manual
iii