Honeywell FlexLine SmartServo 954 Service Manual page 148

COMMISSIONING
7.3.8.4 Commissioning
7.3.8.4.1
Name
[Lowest element offset]
[Second element offset]
if applicable
[Number of elements]
[Element type]
[Measurement type]
[RTD configuration]
140
•
W&M Sealing
via the software. A Notified Body can set his password via
[W&M notified body seal
[W&M
setting
the related password. This requires a W&M module for
Engauge.
If the primary value of the product temperature is completely
valid, then a W&M indication will be set (e.g. visible in HART
SmartView).
Unsealing: give the [W&M unseal level 1] and [W&M unseal
the level 2] commands successively.
History can be made visible via [W&M seal history].
Commissioning Parameters for 1 or 2 RTDs (3- and 4-wire) Temperature
Calculations
NOTE: Make sure the RTD/MPT jumper is set to RTD.
☛
The following entities must be set by Engauge or HART
SmartView for a correct functioning of the FII-RTD module in
an instrument. The default values are available after
initialization of the non-volatile memory.
Explanation
The distance from tank zero
till the first RTD
The distance from tank zero
till the second RTD
The number of RTDs used
The type (material) of the
used RTDs
Selects RTDs, MPT, or
MRT.
Selects how the RTDs are
positioned.
Service Manual
954 SmartServo FlexLine
1
: This board can be electronically s ealed
password]. He can apply the seal by
seal]. Here some data logging is filled in and
Value Range
floating point number:
<-x.x .. +x.x>
floating point number:
<-x.x .. +x.x>
<1..2>
<Pt100 large + small>
<Ni191>
<PtCu100>
<Cu100>
<Cu90 enraf + beacon + weston/
solartron/nulectrohms>
<Sangamo MRT>
<Sangamo spot>
<RTD 3wire>
<RTD 4wire>
<MPT>
<MRT>
<RTD1 in tank>
<RTD1 and RTD2 in tank>
<RTD1 in tank and RTD2
ambient> <RTD1
bi t>
Part No.: 4417340 Revision 1
Default
<80.0>
<0.0>
<0>
<No type>
<No type>
<No configuration>