A Typical Flexconn Pcb Layout - Honeywell FlexLine SmartServo 954 Service Manual

SYSTEM ARCHITECTURE
Figure 4-3
18
Each FlexConn PCB consists of a generic and a specific electronic part.
The generic part can be found on any FlexConn modules. The specific
electronics part represents an application-specific function.
See
Figure 4-3.

A typical FlexConn PCB layout

The following parts are available on the generic electronics part.
 The program memory
This memory contains the module-specific software.
 The microprocessor / controller
The microprocessor executes the module-specific software stored in
the program memory.
 The non-volatile memory
Service Manual
954 SmartServo FlexLine
Part No.: 4417340 Revision 1