Board Specific - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.4.2

Board specific

Name
[Date and time]
[Write date and time]
[Set date and time]
[Run hours]
[Magnet
temperature]
[Voltage CPU core]
[Board W&M
intended]
[W&M unseal step 1]
[W&M unseal step 2]
66
Value Range
<enable>
<disable>
Service Manual
954 SmartServo FlexLine
Default Value Explanation
Shows the date and
time of the RTC chip.
<2018,1,1,0,0,0> Here you write the
actual date and time
you want to set.
This command sets
the new entered date
and time to the RTC.
Shows the amount of
hours the servo
continuously has run.
Shows the magnet
temperature with a
status whether it is
valid or not.
Shows the measured
voltage of the CPU
core.
<disable> This board can be
W&M sealed.
Therefor the user
needs to set this
board as W&M
intended.
This command can be
given if the user
wants to remove the
(electronic) W&M
seal.
It is done in 2 steps.
This is step 1.
Next entity is step 2.
This command is step
2 of the remove W&M
seal procedure. After
this command the
seal is removed.
Part No.: 4417340 Revision 1