Software Specifications; Accepted Hart Addresses - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.7.3

Software Specifications

7.3.7.3.1
HART Address
00
01
02
03
04
HART Address
05
06
07
08
09
10
11
12
13
14
15
Table 7-2
114
General
The main function of the FCI-HT software is to measure HIMS product
density, by connecting the FCI-HT board via the HART bus to 2
pressure sensors (P1 and P3), and via the FlexConn bus to a product
level sensor and an optional water level sensor.
The alternative function is to connect up to 5 generic HART devices
operating in multi-drop digital mode or 1 generic HART device
operating in analog mode.
The FCI-HT software only supports HART devices with the following
addresses.

Accepted HART addresses

☛
Before proceeding with commissioning, first check the maximum
start-up current of all connected HART devices.
☛
Make sure the HART address of the installed device(s) are in
accordance with Table 7-2
Service Manual
954 SmartServo FlexLine
Function
Reserved for HART device in analog mode
Reserved for P1 pressure sensor
N/A Reserved for future use
Reserved for P3 pressure sensor
HART generic sensor
Function
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
HART generic sensor
Accepted HART addresses
.
Part No.: 4417340 Revision 1