Operational Commands - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.4.9

Operational commands

Name
[Host command mode]
[Freeze]
[Test gauge]
Part No.: 4417340 Revision 1
Value Range
<Enable>
<Disable>
Service Manual
954 SmartServo FlexLine
Default Value Explanation
All <Enable>
With this entity the user
can enable or disable
the following
commands:
-Interface 1
-Interface 2
-Interface 3
-Block
-Calibrate
-Dip mode
-Freeze
-Interface profile
-Lock test
-Test gauge
-Tank profile
-Unlock
-Density water dip
-Water density dip
-Test
-Lock to level
-Lock test to level
This command stops
the motor. This
situation will be
maintained until a
[Unlock] command is
given.
This command will rise
the displacer 6 cm. up
and after that the
interface is searched
again. (reproduction
test)
75