Status Behavior - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.6.4.3
102
☛
If [Local] [Monitor Mode]
☛
From the [Monitor Mode], select [Remote].
☛
Select [Remote Threshold Source],
 If the [Monitor Mode]
value is compared against the value set in the
entity. The behavior is modified by the
and the [Hysteresis]
can be set to either
If the [Threshold Mode]
relay is activated if the scanned PV or SV is greater than or
equal to the
deactivated if the scanned PV or SV is less than the
[Threshold]
If the [Threshold Mode]
relay is activated if the scanned PV or SV is greater than or
equal to the
deactivated if the scanned PV or SV is less than the
[Threshold]
☛
From the [Monitor Mode], select [Local].
☛
Select [Threshold Mode],
<Treat as LA>.
☛
Select [Hysteresis],

Status Behavior

The Status Behavior entity determines what happens to the relay if the
health of the scanned PV or SV differs from Good. The
Behavior] should be set to one of the following options:
UNCERTAIN>, or <Not Used>.
If the [Status Behavior]
health is Bad, the respective relay will be activated.
If the [Status Behavior]
PV or SV health is Bad or Uncertain, the respective relay will be
activated.
Service Manual
954 SmartServo FlexLine
is to be set, skip to next bullet ( ).
set desired value.
is set to [Local],
entities. The
<Treat as HA>
entity is set to
[Threshold] entity value, and the relay is
entity value minus the
entity is set to <Treat as LA>, the
[Threshold] entity value, and the relay is
entity value plus the
and choose either
set desired value.
is set to <BAD>, and the scanned PV or SV
is set to <BAD-UNCERTAIN>,
the scanned PV or SV
[Threshold]
[Threshold Mode]
[Threshold Mode] entity
or <Treat as LA>.
<Treat as HA>,
[Hysteresis] entity value.
[Hysteresis] entity value.
<Treat as HA>
[Status
<BAD>, <BAD-
and the scanned
Part No.: 4417340 Revision 1
the
or