Status Entities In Engauge; Generic Entities In Engauge; Board-Specific Entities In Engauge; Function-Generic Entities On Engauge - Honeywell FlexLine SmartServo 954 Service Manual

SYSTEM ARCHITECTURE

Status Entities in Engauge

Generic Entities in Engauge

Board-specific Entities in Engauge

The "Generic" tab page is always followed by the "Board specific" tab page, in which the board-
specific entities are placed. These entities are specific for each individual FlexConn module type. The
board-specific entities are further described in section COMMISSIONING
Specific Entities on Engauge
The specific entities are described in section COMMISSIONING

Function-generic Entities on Engauge

Part No.: 4417340 Revision 1
Each board descriptor user interface starts with the tab page "Status". In
this tab page the "Health" and "Commissioning" entities for the complete
module and the individual functions are placed.
The "Status" tab page is always followed by the "Generic" tab page, in
which the general commands and diagnostics entities are placed.
.
After the board-specific tab page, for each implemented function on the
concerned FlexConn module a specific tab page follows.
For example, for the FII-DO module, the below listed specific tab pages
are present:
 Relay 1
 Relay 2
 Relay 3
 Relay 4
In case of complex functions, extra tab pages can exist, containing the
specific functions involved.
The function category "generic entities" are placed at the bottom of each
function tab page in Engauge.
For each category (sensor, digital I/O, communication, display), the
basic Engauge version contains only one entity:
"Function identification".
With this entity, you can change the function name, which is available
on the HART SmartView Primary Value screen and in Engauge.
Service Manual
954 SmartServo FlexLine
7
7
29