Honeywell FlexLine SmartServo 954 Service Manual page 184

COMMISSIONING
176
11. Check the Firware version is correct, and if you want to
reset board and Novram you can reset using this tab.
12. Open the machine where Engauge tool is installed.
13. Create new site. Refer Installation and Operation Manual
Engauge 2.6 - Professional.
14. Add device. Refer Installation and Operation Manual
Engauge 2.6 Professional.
15. Add field connector. See Installation and Operation Manual
Engauge 2.6 - Professional.
16. Add Tank. See Installation and Operation Manual Engauge
2.6 - Professional.
17. Add gauge. See Installation and Operation Manual Engauge
2.6 - Professional.
18. Scan the field for connected instruments and field
connectors (interfaces).
19. Add the GPU and Flexconn address in the Engauge tool.
Service Manual
954 SmartServo FlexLine
Part No.: 4417340 Revision 1