General; Target Group For This Service Manual; Structure Of This Manual; Trademarks - Honeywell FlexLine SmartServo 954 Service Manual

GENERAL

1 GENERAL
1.1

Target Group for this Service Manual

1.2

Structure of this Manual

Chapter Title
1 - GENERAL
2 – SAFETY & SECURITY
3 – PRINCIPAL OF
SERVO MEASUREMENT
4 - SYSTEM
ARCHITECTURE
5 - SERVICE TOOLS
6 - INSTALLATION
7 - COMMISSIONING
8 - OPERATION
9 - MAINTENANCE
10 – DENSITY OPTION
11 TROUBLESHOOTING
1.3

Trademarks

Part No.: 4417340 Revision 1
The 954 SmartServo FlexLine Service Manual is intended for service
engineers who are assigned to commission the 954 SmartServo
FlexLine.
Description
This chapter provides the introductory information for the
manual.
This chapter provides all the essential and mandatory safety
instructions, precautions, and measures. It also describes
the safety conventions used, the labelling information, and
the compliance information.
This chapter provides the basic principles of servo based
measuring system.
This chapter provides an introductory impression of the 954
SmartServo FlexLine's modular-shaped hardware
architecture.
This chapter provides the description of the SmartView and
the Engauge service tool.
This chapter provides a reference to the Installation Guide
for the 954 SmartServo FlexLine to make sure the relevant
module(s) are accurately installed, before starting the
commissioning.
This chapter provides the information required for an
accurate commissioning of one or more 954 SmartServo
FlexConn modules.
This chapter describes the basic operation of the 954
SmartServo FlexLine.
This chapter provides tests that can be executed for
preventive maintenance and procedures for physical part
replacement.
This chapter provides the information required to perform
density measurements.
This chapter provides descriptions for the diagnostic data
and procedure for testing and checking if the displacer is
running freely.
®
HART is a registered trademark of the HART Communication
Foundation.
Service Manual
954 SmartServo FlexLine
1