Honeywell FlexLine SmartServo 954 Service Manual page 102

COMMISSIONING
Name
[SAT frequency limit]
[SAT intended interface]
[SAT invalidate level]
[SAT level last fail]
[SAT level last executed]
[SAT minimum level
executed]
[SAT maximum level
executed]
[SAT highest number of
retries]
[SAT number of
executed tests]
[SAT status]
[SAT time elapsed since
last SAT]
[SAT RTC last fail]
94
Value Range
<Interface 1>
<Interface 2>
<Interface 3>
<enable>
<disable>
Service Manual
954 SmartServo FlexLine
Default Value Explanation
<120> Determines the
maximum frequency
change when the
displacer has been
raised.
<Interface 1> Determines at/around
which interface the SAT
is performed.
<disable> Determines if the actual
interface will go the
health BAD during the
SAT.
999.9999 Shows the level at
which the last SAT
failed.
Shows the interface
level at the moment the
SAT was performed.
Shows the minimum
interface level where
the SAT was
performed.
Shows the maximum
interface level where
the SAT was
performed.
Shows the number of
retries in case a SAT
performance failed.
Shows the number of
SAT's performed since
the gauge was
powered up.
Shows the result of the
last performed SAT.
Shows the elapsed
time since the previous
SAT
Shows the date of the
RTC when there was a
SAT fail.
Part No.: 4417340 Revision 1