Honeywell FlexLine SmartServo 954 Service Manual page 165

COMMISSIONING
Name
[QV Link function
instance]
[Linked Primary Value]
[Linked Secondary
Value]
[Linked Tertiary Value]
[Linked Quarternary
Value]
Name
[HART SV unit code]
[HART TV unit code]
[HART QV unit code]
[Configuration changed
Counter]
[Device ID]
[Device Type]
[Manufacturer ID Number]
[Number of Preambles]
[Number of Response
Preambles]
[Fixed Current Value]
[Loop Current Mode]
[Percentage of Range]
Part No.: 4417340 Revision 1
Explanation
Function Instance of the
linked QV board
PV / SV value of linked PV
board in the set unit code
PV value of linked SV
board in the set unit code
PV value of linked TV board
in the set unit code
PV value of linked QV
board in the set unit code
Explanation
Unit code for linked SV
Unit code for linked TV
Unit code for linked QV
Increments every time the
configuration is changed
Same as Enraf Serial
number. This is a unique
number to every board.
Device type registered with
the HART Communication
Foundation
Manufacturer ID registered
with the HART
Communication Foundation
Number of preambles
required for a request from
the HART master
Number of preambles in the
HCI-HAO response stream
Fixed analog output current
set by HART command 40
If HART mode selected is
<Standard 4-20mA>, then it is
enabled.
If HART mode selected is
<Fixed 4-20mA>, then it is
disabled.
Percentage of current PV
with respect to the limits set
Service Manual
954 SmartServo FlexLine
Function
Default Value
Part
Board
<0>
<0>
<0>
<0>
<0>
Function
Default Value
Part
<UNIT_CODE_
Function 1
UNKNOWN>
<UNIT_CODE_
UNKNOWN>
<UNIT_CODE_
UNKNOWN>
<0>
<127>
<148>
<7>
<7>
<0> Function 2
<Enabled>
<0>
Function
Board Specific
Function
Communica
tion (HART
communica
tion)
Sensor
(Analog
Output)
157