Errors - Honeywell FlexLine SmartServo 954 Service Manual

TROUBLE SHOOTING
Status code
(SmartView)
6292
6293
6294
6295
6296

Errors

Status code
(SmartView)
6130
6131
6132
6133
6134
6144
6146
6148-6154
6156
6158
6159
6160
Part No.: 4417340 Revision 1
Description
(Engauge)
Wrong HART units device address
13
Bad HART status device address
11
Bad HART status device address
12
Bad HART status device address
13
Weight in vapor bad for density tilt
compensation
Codes in the range 6130-6271 are error codes. Errors will set the
status of the Primary value to BAD.
Description
(Engauge)
Frequencies F0..F3 not
commissioned
Drum circumference not
commissioned
Motor limits high or low not
commissioned
Tank top level not commissioned
Reference level not
commissioned
Frequency sensor failed to start
up
Find positions failed encoder
problem
Sensor frequencies out of range
Frequency coefficients out of
range
Find positions failed offset to big
Find positions failed wire tension
error
Find positions failed no space
Service Manual
954 SmartServo FlexLine
Remarks
RIC warning
RIC warning
RIC warning
RIC warning
Remarks
Commissioning error (refer to section
7.4).
Commissioning error (refer to section
7.4).
Commissioning error (refer to section
7.4).
Commissioning error (refer to section
7.4).
Commissioning error (refer to section
7.4).
Hardware error of the frequency sensor.
Hardware error of the reference
encoder.
Calibration of the frequency sensor
failed. Please check [Frequency 0] -
[Frequency 3].
Calibration of the frequency sensor
failed.
The displacer level is unreliable. The
reference encoder needs to be
calibrated in maintenance mode (refer to
section 9.6)
The reference encoder could not be
checked because the wire tension is too
low or too high. Please check the wire
and displacer.
The motor limits are too close to each
other. Find positions needs 10mm up or
downwards.
287