Unlocking (Locking) The Motor Block; Motor Block (Un)Locked - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING

Unlocking (locking) the motor block

Figure 7-4
Part No.: 4417340 Revision 1
 The motor block is locked during transport to protect the
force transducer. After installing the measuring drum and
displacer, the motor block locking device must be unlocked.
 Open the electronic compartment cover (front cover).
 Locate the transport bracket (see
remove) the Allen key screw and turn the transport bracket
the opposite way. Use screwdriver for Allen key screws M4
(item 8 of the Honeywell Enraf tool set).
Fix the Allen key screw of the transport bracket. • Check the

span wire. It should always be under tension while both
ends are correctly positioned in the levers of the motor block
and force transducer.
 Close the electronic compartment cover.

Motor block (un)locked

Note: Use the same procedure for locking the motor block if the 954
SmartServo FlexLine needs to be removed.
Service Manual
954 SmartServo FlexLine
Figure 7-4) Loosen (do not
55