2.3 Product Nomenclature
The following diagram illustrates the nomenclature of the DeviceNet Unit.
Ground line:
Connect to the terminal marked "G" on the Servo Driver.
Rotary switches ( × 1, × 10) :
Used to set the DeviceNet node address.
Rotary switch (DR) :
Used to set the baud rate for DeviceNet.
Connector for Setup Tool (CN11) :
RS-232C connector for Setup Tool
LED (MS) :
Module status LED indicator
LED (NS) :
DeviceNet network status LED indicator
Connector for DeviceNet communications (CN6):
For connection to any device that conforms
to DeviceNet specifications
Fig. 2.3 DeviceNet Unit
2-5
Connector for I/O signals (CN4):
For connection to external I/O signals
and fully-closed encoder signal
2.3 Product Nomenclature
2