Omron OMNUC W Series Manual page 234

A.94
A.94: Parameter Setting Warning
Display and Outputs
Alarm Outputs
Alarm Code Outputs
ALO1 ALO2
OFF OFF
Note OFF: Output transistor is OFF (alarm state). ON: Output transistor is ON.
Status and Remedy for Alarm
When the command was sent
Cause
A A value outside the DeviceNet communications
setting range was set.
B • A parameter No. or data settings are incorrect
at the Parameter Write Command.
• Parameter No. settings are incorrect at the
Parameter Read Command.
9-23
9.3 Troubleshooting with Alarm Displays
ALM Output
ALO3
ON ON
A, B
Reset correctly.
Reset correctly.
Remedy
9