Omron OMNUC W Series Manual page 161

6 DeviceNet Communications
6.7.2 Command Method
6
Unit Reset Command
The Unit is reset by setting the Unit Reset Command and changing the Command Start
Command (C_STRT) from 0 to 1. When the Unit Reset Command is executed, the Unit
Ready Flag (READY) is changed from 1 to 0. When the reset processing for the DeviceNet
Unit and the W-series Servo Driver has been completed, the Unit Ready Flag changes from
0 to 1.
The Unit reset operation process is outlined below.
• If the axis is travelling, it decelerates to a stop and the remaining travel distance is dis-
carded.
• If the present status is Servo ON, it changes to Servo OFF.
• If an alarm occurs, it is reset.
• All of the latest DeviceNet Unit parameters are stored in flash memory.
6-64