2 Outline Drawings and Nomenclature
2.4 Mounting the DeviceNet Unit
Mounting Type
Base Mounted
2
Rack Mounted
This section describes how to mount a DeviceNet Unit on the W-series Servo Driver.
Prepare the screws for connecting the ground line as shown in the following table:
Servo Driver Models
R88D-WTA3HL to 02HL
R88D-WTA3H to 10H
R88D-WT15 to 50H
R88D-WT60
R88D-WTA3HL to 02HL
R88D-WTA3H to 10H
R88D-WT15H
R88D-WT20H/30H/50H
By mounting DeviceNet Unit, the W-series Servo Driver can be used in a DeviceNet network.
Use the following procedure to ensure DeviceNet Units are mounted correctly.
1. Remove the connector cover from the CN10 connector on the Servo Driver.
CHARGE
Screw
×
M3
10 round–head screw
(spring or flat washer)
×
M4
10 round–head screws
(spring or flat washer)
×
M4
8 round–head screw
(spring or flat washer)
×
M3
10 round–head screw
(spring or flat washer)
×
M4
10 round–head screw
(spring or flat washer)
×
M4
10 round–head screw
(spring or flat washer)
CN10
Connector cover
POWER
2-6
Remarks
−
−
−
Frontl panel mounting fitting
(R88A-TK01W) is necessary.
Frontl panel mounting fitting
(R88A-TK02W) is necessary.
Frontl panel mounting fitting
(R88A-TK03W) is necessary.