Trace Setting Object (0X67) - Omron OMNUC W Series Manual

10.2.9 Trace Setting Object (0x67)

Class and instances of the Trace Setting Object (0x67) are shown below.
Class
Instances
Attributes (Instance #1: Explicit Message)
No. Access Name
10
Get/Set Data Trace 1
11
Get/Set Data Trace 2
12
Get/Set I/O Trace 1
13
Get/Set I/O Trace 2
14
Get/Set Sampling Cycle
15
Get/Set Trigger Target
16
Get/Set Trigger Level
17
Get/Set Edge Type
18
Get/Set Pre-trigger
19
Get/Set Start Trace
20
Get Trace State
• Attributes: None supported
• Services: None supported
Data Type
UINT Specifies the data trace 1 target.
UINT Specifies the data trace 2 target.
UINT Specifies the I/O trace 1 target.
UINT Specifies the I/O trace 2 target.
DINT Specifies the sampling cycle.
µs
Unit:
UINT Specifies the trigger condition.
UINT Specifies the trigger level.
UINT Specifies the edge type.
UINT Specifies the amount of pre-trigger data.
UINT Specifies the trace execution status.
0: No-operation (initial status)
1: Trace Start Command
2: Trace Stop Command
UINT Stores the trace execution status.
0000 Hex: Initial status
0001 Hex: Tracing data.
0002 Hex: Trace completed.
0010 Hex: Trace interrupted.
0011 Hex: Setting error
10-25
Description
(Read enabled.)
10.2 DeviceNet Attributes
Setting Default
Range Setting
0 to 4 0
0 to 4 1
80 to 8D Hex 83 Hex
80 to 8D Hex 81 Hex
250 to 250
8191750
0 to 4 0
0000 to FFFF 0
Hex
0 to 2 0
0 to 999 0
0 to 2 0
−
0
10