Error Codes For Message Communications - Omron OMNUC W Series Manual

10 Appendix

10.3.3 Error Codes for Message Communications

10.3.3 Error Codes for Message Communications
10
If an Explicit Message has been sent and then is not completed normally, an error code (2
bytes) is added after service code "14 Hex," and an Explicit Message is returned.
The message communications error codes are shown below.
Error Code Error Name
09FF Hex Invalid attribute value There is an error in the attribute data for the requested
0BFF Hex Already in requested
mode/state
0CFF Hex Object state conflict
0EFF Hex Attribute not settable
10FF Hex Device state conflict
13FF Hex Not enough data
14FF Hex
Attribute not sup-
ported
15FF Hex Too much data
10-32
Description
service.
The specified object is already in the requested mode
or state.
The specified object is in a state in which the
requested service cannot be executed.
The requested setting service has specified an
attribute that cannot be changed.
The specified device is in a state in which the
requested service cannot be executed.
The requested service is not providing enough data to
execute the processing.
The requested service specified an unsupported
attribute.
The requested service included invalid data.