Table of Contents
Advertisement
4.7.
Submenu PR.OPT - Configuring programs
Messaggio
Acronimo
a scorrimento
PR.OPT
PROGRAMMER
CONFIGURATION
Password
d'accesso
Livello 1
Parameter
Selecting program
PR.OP.N
Number of first step
FI.STP
assigned to program
Number of last step
LA.STP
assigned to program
Restart mode
Strt
Type of control after
RST.SP
program restart
Option to start
WAIT.S
execution of program
Action at end
End
of program
Message associated at
LIMIT
the end of the program
Messaggio associato
alla fine del
MSG.EN
programma
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 72
Descrizione
Lets you configure the 16 programs manageable by the programmer.
The parameters are configured for each program to be used.
The Programmer function must previously be enabled with the
MODE.1 and/or MODE.2 menus, assigned, respectively, with
PID.1 and PID.2, with parameter PROGR = On.
If "Simplified Programmer" mode is active (S.PROG parame-
ter set to EN.FUN )), the controller can manage 12 programs,
each of which has up to 16 configurable steps.
For more information on configuring the programmer, see
paragraph "5.13. Setpoint programmer" on page <?>.
Pag.
73
73
73
22
73
23
74
74
74
Advertisement
Table of Contents
